Before Using The Unit; Operation Procedure In Destination Selection Mode - Sony HDW-1800 Bedienungsanleitung

Before Using the Unit

When turning on the POWER switch for the first time or
after executing maintenance menu item "M49: RESET
ALL SETUP", the unit enters the mode for selecting a
1)
destination (J or SYL
Select a destination by following the operation procedure
in destination selection mode.
Once destination selection is executed, the unit does not
enter destination selection mode when the POWER switch
is turned on again, and the unit operates in accordance with
the destination selection.
1) J for Japan, and SYL for any destination other than Japan.
For details about maintenance menu item M49, refer to the
Maintenance Manual.
Note
Be sure to select a destination before using the unit. If no
destination is selected, the unit cannot perform playback
and recording properly.
Operation Procedure in Destination
Selection Mode
1
With the destination setting being "NO-SET", turn on
the POWER switch.
The following screen appears on the LCD.
2
Select F3 (–) or F4 (+).
You can select the destination "50 : SYL", "59.94 :
SYL", or "59.94 : J".
DESTINATION SETTING
*NO-SET
50:SYL
59.94:SYL
59.94:J
Select DESTINATION.
Push SET button.
3
Press the F9 (SET).
Pressing the F9 (SET) sets the destination to the
selected destination.
Screen 1 is displayed for about 10 seconds. When
screen 1 is replaced by screen 2, turn off the POWER
switch.
16
Before Using the Unit
).
Screen 1
DESTINATION SETTING
INITIALIZING...
About 10 seconds
Screen 2
DESTINATION SET
COMPLETE
59.94:SYL
TURN OFF/ON POWER !!
To return the destination setting to "NO-
SET" (not selected)
Reset all the unit settings to the factory settings using
maintenance menu item "M49: RESET ALL SETUP".
For details about the maintenance menu, refer to Section
3 in the Maintenance Manual Volume 1.
Note
If you execute maintenance menu item M49, all the
settings including the setup menu settings are reset.