B) Attaching The Edge Trimming Wheel; Attaching The Auxiliary Handle - Toolcraft Ras-200 Bedienungsanleitung

Fig. 3
Screw on the protective
cover here
• Insert the screw for the protective cover from above and tighten it. Make sure that the screw hole is located directly
below as shown in Fig. 1.

b) Attaching the edge trimming wheel

• Attach the edge trimming wheel (11) with 2 screws as
shown in Fig. 4.
c) Attaching the auxiliary handle
Fig. 5
• Squeeze here on both sides of the handle adjustment (5) and put on the auxiliary handle (13) so that it clicks into
place.
Pull out the line up to the
cutting blade
Fig. 6
Fig. 4
31