Part 2. Preparation; Supplied Items; Interconnections - Sony SDX-D550V Benutzerhandbuch

Part 2. Preparation

Supplied Items

Interconnections

12
Part 2. Preparation
After you confirm that you have all of the required accessories for your
installation, connect the drive to the host computer, and select the SCSI ID
with the rotary switch on the rear panel.
When you first open the box, make sure it contains the following items.
Contact your supplier if anything is missing or broken.
• AIT Drive Unit
• Power Cable
• Operator's Guide
The SCSI bus allows connection of up to fifteen peripherals to the host
computer. Use a SCSI cable with a half pitch 68 pin connector.
Precautions
• Switch off the host computer and peripherals before connecting the SCSI
cable.
• Make sure the SCSI connectors are pressed tightly together.
• If this unit is the last (or only) device on the Wide SCSI bus, make sure to
connect a terminator to the appropriate unused Wide SCSI connector. Using
an incompatible terminator may damage the unit.
• With an Ultra Wide SCSI bus, the total length of the SCSI cable(s)
connecting the host computer and the last device on the SCSI bus should be
less than 12 meters (39 feet). (If a SCSI single-end host adapter is at the end
of the SCSI bus, use less than 1.5 meters of SCSI cable.)
Terminator
AC power
*1
It should be less than 1.5 meter, if connected to single-ended SCSI host adaptor.
*1