Inhaltsverzeichnis
Werbung
4. Always handle the drive by its edges. Do not touch any exposed printed
circuitry, components, or connector pins.
5. While installing the drive, avoid all unnecessary handling. Rough handling
can damage the heads, rotating disks, and bearings inside the drive
housing.
6. If you must put the drive down, place the antistatic bag on a flat, padded
surface and place the drive on the bag with the component side facing up.
Note: If you want to install the drive in a 5.25-inch bay, you will need to
purchase a universal bay conversion kit which is available at many local
computer supply stores.
Step 3. Mounting the drive in the bay
You can mount the drive horizontally or vertically based on the location of the
bay in your chassis. The ThinkStation D10 and S10 series computer systems
provide plastic brackets for you to mount your hard disk drives. Alternatively,
you can mount your hard disk drive using screws in a bay without a bracket.
The screws should be commercially available at your local computer retailer.
To mount the drive using the bracket:
1. Pull the bracket out of the bay by pressing the snaps (�1�) and pulling the
handle (�2�).
Chapter 1. About the ThinkStation Serial Attached SCSI (SAS) hard disk drive
5
Werbung
Inhaltsverzeichnis
