Attaching The Vacuum Extraction Adapter (With Reducer Piece); Switching On / Off; Preselecting The Rotation Speed; Table Of Indicative Rotational Speeds (For Guidance Only) - Parkside POF 1300 Bedienungs- Und Sicherheitshinweise

Attaching the vacuum extraction
Q
adapter (with reducer piece)
m Warning: Always pull the mains plug is out
of the socket before doing any work on the device.
This precaution is intended to prevent you from
unintentionally starting the device.
Note: Remove the router bit before you attach the
vacuum extraction adapter
j
Place the vacuum extraction adapter
the base plate . Fasten the vacuum extraction
5
adapter to the base plate
31
screws . Screw the two screws
30
below.
If it is necessary to use the reducer piece
can be pushed into the vacuum extraction
adapter .
31
j
Connect a vacuum extraction device suitable
for extracting dust and chips by means of a
suction hose to the vacuum extraction adapter
or to the reducer piece
31
Operation
Q
Connect the device by its mains plug to a power
source supplying 220 V - 230 V ~ 50 Hz.

Switching on / off

Q
Switching on
j
To switch off the device first press the safety
lock-out and keep it depressed. Then press
24
the ON / OFF switch
Switching off
j
To switch off the device, release the ON / OFF
switch again.
23
Illuminating the routing area
j
The integrated illumination for the routing area
lights up and can be switched off again by
pressing the On / Off switch
.
31
on to
31
using the two
5
in from
30
, it
32
.
32
.
23
.
23
Preparing for use / Operation
Preselecting the
Q
rotation speed
j
Set the required rotational speed using the
thumbwheel for speed preselection
1-2 = low rotational speed
3-4 = medium rotational speed
5-6 = high rotational speed
j
If possible always determine the optimum setting
beforehand using a practical test.
j
If you have been working for a long period using
a low rotational speed, you should cool the
device by running it at the highest speed for
about 1 minute under no-load conditions.
Table of indicative rotational
Q
speeds (for guidance only)
Material Router
bit
Aluminium 4-15 mm
16-40 mm
Plastic 4-15 mm
16-40 mm
Chipboard 4-10 mm
12-20 mm
22-40 mm
Softwood 4-10 mm
e.g.: spruce, 12-20 mm
pine, fir 22-40 mm
Hardwood 4-10 mm
e.g.: maple, 12-20 mm
birch, oak, 22-40 mm
cherry
The indicative values in the table are for guidance
only. The required rotational speed depends on the
material and the working conditions and should be
determined by means of a practical test.
.
25
Speed
setting
1-2
1
2-3
1-2
3-6
2-4
1-3
5-6
3-6
1-3
5-6
3-4
1-2
GB/IE/CY 13