Safety Notes; Installation Instructions; Symbol Description - HANSGROHE Talis S serie Gebrauchsanleitung, Montageanleitung

Safety Notes

Gloves should be worn during installation to prevent
crushing and cutting injuries.
The product may only be used for bathing, hygienic
and body cleaning purposes.
The hot and cold supplies must be of equal
pressures.

Installation Instructions

• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The pipes and the fixture must be installed, flushed
and tested as per the applicable standards.
• The plumbing codes applicable in the respective
countries must be observed.
• The drain valve must only be used as intended. It is
not allowed to attach other objects to the drain
valve, for example a semi-pedestal.
• The mixer can not used together with a continuous
flow water heater.
Technical Data
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Thermal disinfection:
The product is exclusively designed for drinking water!
4
max. 1 MPa
0,1 - 0,5 MPa
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
max. 70°C
max. 70°C / 4 min
Assembly (see page 32)
English

Symbol description

Do not use silicone containing acetic acid!
Adjustment (see page 34)
Set hot water limiter
Dimensions (see page 40)
Flow diagram (see page 40)

Rate of flow mixer

Rate of flow handshower
Maintenance (see page 37)
The check valves must be checked regularly according
to DIN EN 1717 in accordance with national or
regional regulations (at least once a year).
Spare parts (see page 41)
Special accessories (order as an extra)
• seal #98996000 (see page 32)
Cleaning (see page 38)
Operation (see page 36)
• Hansgrohe recommends not to use as drinking water
the first half liter of water drawn in the morning or
after a prolonged period of non-use.
• Due to the design of the Bidette fittings, a small
65°C
amount of water will leak at the outlet of the fitting
when the hand shower is running.
Test certificate (see page 44)