Disposal And Recycling - Parkside PTBMOD 710 A1 Bedienungs- Und Sicherheitshinweise

• Interfaces by running over the power supply cables.
• Insulation damage by pulling off the wall outlet.
• Cracks due to ageing of the insulation.
Such defective power supply cables must not be used and are
extremely dangerous to life because of the insulation damage!
Check power supply cables regularly for damage. Make sure
that the power cable is not connected to the mains supply
when you check.
Electrical connection cables must comply with the applicable
VDE and DIN provisions. Only use connection cables with the
marking H05VV-F.
The printing of the type designation on the connection cable
is mandatory.
If it is necessary to replace the power cable this should be
done by the manufacturer or their representative to avoid
safety hazards.
14.3 AC motor
The mains voltage must be 220 - 240 V ~ 50Hz.
• Extension cables up to 25 m length must have a cross sec-
tion of 1.5 mm .
2
Connections and repairs of electrical equipment may only be
carried out by an electrician.
Please provide the following information in the event of any
enquiries:
• Type of current for the motor
• Motor data - type plate

15. Disposal and recycling

The equipment is supplied in packaging to prevent it from be-
ing damaged in transit. The raw materials in this packaging
can be reused or recycled.
The equipment and its accessories are made of various types
of material, such as metal and plastic. Defective components
must be disposed of as special waste. Ask your dealer or your
local council.
The packaging is wholly composed of
environmentally-friendly materials that can be
disposed of at a local recycling centre.
Contact your local refuse disposal authority for
more details of how to dispose of your worn-out
electrical devices.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must not be dis-
posed of together with domestic waste in compliance
with the Directive (2012/19/EU) pertaining to waste
electrical and electronic equipment (WEEE). This prod-
uct must be disposed of at a designated collection point. This
can occur, for example, by handing it in at an authorised col-
lecting point for the recycling of waste electrical and elec-
tronic equipment. Improper handling of waste equipment may
have negative consequences for the environment and human
health due to potentially hazardous substances that are often
contained in electrical and electronic equipment. By properly
disposing of this product, you are also contributing to the ef-
fective use of natural resources. You can obtain information
on collection points for waste equipment from your municipal
administration, public waste disposal authority, an authorised
body for the disposal of waste electrical and electronic equip-
ment or your waste disposal company.
GB/MT 43