Dell PowerConnect 60 serie Handbuch Zum Einstieg Seite 14

Wizard Step 4
The following information appears:
Next, an IP address is setup. The IP address is defined on the
OOB port. This is the IP address you use to access the CLI, Web
interface, or SNMP interface for the switch.
To setup an IP address:
Please enter the IP address of the device (A.B.C.D):
Please enter the IP subnet mask (A.B.C.D or /nn):
1
Enter the IP address, for example 192.168.1.100.
2
Press Enter.
3
Enter the IP subnet mask, for example 255.255.255.0
4
Press Enter.
Wizard Step 5
The following information appears:
Finally, setup the default gateway. Please enter the IP address
of the gateway from which this network is reachable
(for example 192.168.1.1):
1
Enter the default gateway, for example, 192.168.1.1.
2
Press Enter.
The following information appears (as per the example parameters described):
This is the configuration information that has been collected:
SNMP Interface = MYSETUPWIZARD@0.0.0.0
User Account setup = admin
Password = **********
Management IP address = 192.168.1.100 255.255.255.0
Default Gateway = 192.168.1.1
12
Getting Started Guide