Service Intervals; Sharpening The Cutting Teeth; Changing The Saw Chain; Servicing The Blade Bar - Parkside PHSHE 900 A1 Originalbetriebsanleitung

MT
GB

Service intervals

Carefully perform the maintenance tasks listed in the following table on a regular basis.
Regular servicing of your unit will extend the life of your equipment. Additionally, you will
achieve optimum cutting performance and prevent accidents.
Service intervals table
Machine part
Complete ma-
chine
Accessible
screws and nuts
Chain wheel
Saw chain
Blade bar

Sharpening the cutting teeth

Have the saw chain sharpened by a
specialist, or proceed in accordance with
the operating manual for your saw chain
sharpening device. Sharpening a saw chain
requires some practice. Replacing the saw
chain is preferable in case of doubt.

Changing the saw chain

Never attach a new saw chain onto
worn teeth, or onto a damaged or
worn blade bar.
1. Switch the device off and remove the
mains plug.
2. Release the nut (
chain wheel cover (
3. Remove the old saw chain (
The mounting and tensioning of the new
saw chain is described in the "Assembly"
chapter.
68
Action
Check condition, replace damaged
parts as needed
Tighten
Check, replace as needed
Check, apply oil, reground or replace 
Check, rotate, clean, apply oil
26) and remove the
27).
20).
Before each use After 10 hrs of use





Servicing the blade bar

The blade bar has to be reversed every
8-10 operational hours in order to ensure
even wear (see the "Servicing and cleaning
- rotating the blade bar" chapter").
1. Switch the device off and remove the
mains plug.
2. Remove the chain wheel cover (
the saw chain (
bar ( 28).
3. Check the blade bar (
Remove burrs and straighten the guide
surfaces with a lat ile.
4. Clean the oil passage to ensure fault-
free, automatic oiling of the saw chain
during operation.
5. Mount the blade bar, saw chain and
chain wheel cover and retighten the
saw chain (see the "Assembly" chapter).
When in an optimal condition, the
oil passages will automatically spray
the saw chain with a little oil a few
seconds after starting the saw.

27),
20) and the blade
28) for wear.