Herunterladen Inhalt Inhalt Diese Seite drucken

Operation; Setting Up; Selecting The Speed - Parkside PTBM 500 B2 Originalbetriebsanleitung

Vorschau ausblenden Andere Handbücher für PTBM 500 B2:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 67
7. Fold the safety device (7) upwards.
Insert the chuck (4) on the taper of the
drill spindle (6). Push the drill chuck
onto the drill chuck tip with a few light
taps. Use a plastic hammer for this pur-
pose.

Operation

Caution! Risk of injury!
- Ensure that you have sufficient
space in which to work and that
you do not endanger other peo-
ple.
- All hoods and protective devices
must be assembled properly be-
fore commissioning.
- Disconnect the mains plug be-
fore changing the setting on the
device.

Setting up

Place the bench drill on a solid surface.
Ideally, bolt the drill to the surface. Use the
two holes in the baseplate (17) for this.

Selecting the speed

1. Release the locking bolt (11) on the
gear cover (8).
2. Open the gear cover (8).
3. Release the retaining bolt (13) on the
motor unit (14).
4. Slide the motor unit (14) forward a little
to release the load on the V-belt (26).
5. Place the V-belt (26) on the desired as-
sembly to reach the specified speed:
Ø [mm]: Ø [mm]:
< 3
< 4
3 - 4
5 - 6
5
7 - 8
6 - 8
9 - 10
> 8
> 10
6. Slide the motor unit (14) back to tensi-
on the V-belt (26) again.
7. The V-belt (26) is correctly tensioned
when it gives way slightly when
pressed.
8. Tighten the retaining bolt (13) on the
motor unit (14) again.
9. Close the gear cover (8). Fasten the
locking bolt (11) on the gear cover .
The gear cover (8) is equipped with
a interlock switch (27). If the gear
cover (8) is not closed correctly, the
device cannot be switched on.
GB
MT
[1/min]:
59

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Inhaltsverzeichnis