Name Of Parts; Unit Installation - Hitachi DHWT-200S-3.0H2E Bedienungsanleitung

NAME OF PARTS

6 NAME OF PARTS
6.1 DHWT(200/300)S‑3.0H2E

 

7 UNIT INSTALLATION

Transport the products as close as possible to the installation location before unpacking.
Check the contents of the package:
- DHWT Model
- Installation and Operation Manual & Documents
7.1 SELECTION PROCEDURE FOR DHWT UNITS
!
C A U T I O N
• DHWT appliance is intended to be installed in an indoor place.
• DHWT installation must be done by professional installers.
• Install the DHWT with sufficient clearance around it for operation and
maintenance as shown in the following figures.
• Install the DHWT where good ventilation is available. Do not install the
DHWT where there is a high level of oil mist, salty air or sulphurous
atmosphere.
7.2 WORKING SPACE
• Check that DHWT are installed vertically.
• For cleaning, use no flammable and no toxic cleaning liquid. The use of flammable agents should cause explosion or fire.
• Cleaning liquid shall be collected after cleaning.
• Pay attention do not trap cables when closing the electrical box cover. It could cause a electric shock.
6 PMML0347B rev.1 - 06/2016



 




• Working with no sufficient ventilation, in an enclosed space, should
cause oxygen deficiency. Toxic gas should be produced when
cleaning agent is heated to high temperature by, e.g., being exposed
to fire.
• Do not install DHWT near any flammable substance.
• When installing some device next to DHWT, keep clearance between
DHWT and any other obstacle of more than 500mm.
Ref. Qty. Name

1 Inspection aperture

1 HSW storage tank

1 External covering

1 Top cover

1 Thermal insulation

1 Control panel

1 Electrical Heater

1 Heating coil

1 Sensor probes

1 DHWT Sensor