AEG Electrolux 12550 G-M Gebrauchs- Und Installationsanleitungen Seite 28

28
Installer instructions
The power cable must only be replaced by the After-Sales Service or by similarly qualified The power cable must only be replaced by the After-Sales Service or by similarly qualified
The power cable must only be replaced by the After-Sales Service or by similarly qualified The power cable must only be replaced by the After-Sales Service or by similarly qualified The power cable must only be replaced by the After-Sales Service or by similarly qualified
personnel personnel personnel personnel. personnel
Conversion to other types of gas
Replacing nozzles
1. Remove the grates.
2. Remove the burner caps and flame spreaders from the rings.
3. Using a socket wrench, unscrew and remove the nozzles, replacing them with those
corresponding to the type of gas used (see "Burner specifications" table on page 25).
4. Refit the parts by carrying out the above operations in reverse order.
5. Then replace the label (located near the gas connection) with the one for the new
type of gas. The latter is included in the bag of injectors supplied.
If the pressure of the gas used is different (or variable) with respect to that provided for, a
suitable pressure regulator for ducted gas (NOT LPG) complying with Standard UNI EN 88
must be installed on the inlet piping.
The use of pressure regulators for liquefied gases (LPG) is allowed provided they comply
with Standard UNI EN 12864.
Minimum flame adjustment
To adjust the minimum flame, proceed as follows.
1. Light the ring as previously described.
2. Turn the cock to the min. flame position.
3. Extract the knobs.
4. Operate on the bypass pin.
When converting from natural gas to LPG, screw down the bypass pin clockwise.
1 Min. flame adjustment bypass pin
When converting from LPG to natural gas, unscrew the bypass pin approx. 1/4 turn.
In any case, the result must be a small and even flame on all the burner crown.
5. Lastly, check that the burner does not go out when quickly turning the cock from
max. to min.
The above adjustment operations can be easily performed, whatever the position or fixing
of the hob on the kitchen unit.
1
1