AEG Electrolux 12550 G-M Gebrauchs- Und Installationsanleitungen Seite 22

22
Instructions for use
Lighting the rings
To obtain the flame more easily, light the ring before placing a pot/pan on the grate.
Press the knob corresponding to the ring and turn it anticlockwise to the "max." symbol.
The lighting symbol (
Do not operate the igniter for more than 15 seconds. If the burner is not lit after 15 seconds,
stop operating the igniter and wait at least 1 minute before trying to light it again.
After lighting the flame, keep the knob pressed for about 5 seconds. This time is necessary
for heating the "thermocouple" and deactivating the safety valve, which would otherwise
stop the delivery of gas.
Then make sure the flame is even and turn the knob to the required setting.
If the flame does not light after several attempts, make sure the "burner cap" and "flame
spreader" are in the correct position.
1 Burner cap
2 Flame spreader
3 Igniter
4 Thermocouple
To turn off the flame, turn the knob clockwise to the symbol .
1 Burner cap flame spreader assembly
2 Burner cap flame spreader assembly
3 Igniter
4 Thermocouple
Manual lighting (in case of a power failure): bring a flame to the ring, press the knob and
turn it anticlockwise to the "max." symbol.
Always lower the flame or turn it off before removing pots/pans from the rings.
If the burner accidentally goes out, close the control knob and wait at least 1 minute before
relighting it.
) is also located in this position. The flame will light automatically.
3
1
2
3
4
1
2
4