ATTENTION!
♦
If the red control LED
that the battery pack
cannot be charged .
♦
If the red and green control LEDs
flash, this means that the battery pack
defective .
♦
Push the battery pack
♦
Switch off the charger for at least 15 minutes
between successive charging sessions .
Also disconnect the power plug from the mains
power socket .
Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack:
♦
Allow the battery pack
the appliance .
Removing the battery pack:
♦
Press the release button
battery pack
.
Checking the battery charge level
♦
Press the battery charge level button
check the status of the battery (see also main
diagram) .
The status will be shown on the battery display
LED
as follows:
♦
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Filling the magazine shaft
Remove the battery before carrying out any
work on the power tool (e.g. maintenance,
changing tools, etc.) as well as during the trans
port and storage of the power tool.
Unintentional activation of the trigger can result in
injury .
♦
Remove the battery pack
♦
Turn the appliance around .
♦
Press the release
♦
Pull the magazine slider
(see fig . B) .
PAT 20-Li A1
flashes, this means
has overheated and
both
into the appliance .
to click into place in
and remove the
to
from the appliance .
together (see fig . B) .
backwards
♦
Fill the magazine shaft
(see fig . C) .
NOTE
►
Ensure the correct position for the nails
(see main diagram, face plate
appliance) .
is
♦
After filling, push the release
zine shaft
place .
NOTE
►
The fill level indicator
magazine contains staples .
Setting the impact force
NOTE
►
Select the lowest impact force sufficient for
stapling . Take into account the length of the
staples or nails you are using as well as hard
ness of the material you are working with .
Increasing the impact force:
♦
Turn the impact force control
Reducing the impact force:
♦
Turn the impact force control
Operation
Switch on
♦
Press the tacker nose
the material that you want to staple until it is
pushed in a few millimetres .
♦
Press the trigger
Switching on the LED work light
♦
Press the button for the LED work light
minate your workspace in unfavourable lighting
conditions .
with staples or nails
on the
into the maga
as far as the stop until it clicks into
shows whether the
clockwise .
anticlockwise .
onto the location on
.
GB │ MT
to illu
│
31
■