Cleaning The Milk Container; Switching Off The Appliance - Whirlpool ACE 102 IX Gebrauchsanweisung

Cleaning the milk container

WARNING
If there is still milk in the container, do not leave it out of the refrigerator for longer than is strictly necessary.
Clean the container each time you prepare milk as described at point 3 in chapter MAKING CAPPUCCINO.
All the components can be washed in the dishwasher, as long as they are placed in the top rack.
1. Turn the milk container lid clockwise and remove it.
2. Remove the milk spout and intake tube.
A
B
3. Remove the pointer by pulling it outwards.
4. Wash all the components thoroughly with hot water and mild detergent. Make sure there is no milk residue left inside the
holes or the groove on the fine end of the pointer.
5. Check that the intake tube and spout are not clogged with milk residue.
6. Replace the pointer, milk spout and intake tube.
7. Replace the milk container lid.

SWITCHING OFF THE APPLIANCE

Each time the appliance is switched off, it performs an automatic rinse which cannot be interrupted.
WARNING
N.B.: in the event of prolonged disuse, press the ON/OFF button (A23), on the side of the machine, in position 0.
Always clean the tubes inside the milk container (C) after preparing milk.
C
D
During rinsing, some hot water is run off from the coffee spouts. Avoid contact with
splashes of water. To switch the appliance off, press the on/stand-by button (A7). The
appliance performs a rinse cycle and then switches off.
A.
B.
C.
E D.
E
E.
GB38
Milk spout
Intake tube
Groove
Pointer
Hole