Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
BUILT-IN INSTALLATION
Check the minimum measurements required for correct installation of the appliance.
The coffee machine must be installed in a column unit, which must in turn be securely fixed to the wall by means of commercial
brackets.
Attention:
•
Disconnect the appliance from the mains before carrying out any installation work or servicing.
•
Kitchen units in contact with the appliance must be heat resistant (min. 65°C).
•
To ensure adequate ventilation, provide an opening on the bottom of the housing (see dimensions in Figure).
Dimensions in mm
Position the runners on the sides of the housing, as shown
in the Figure. Secure the runners with the screws supplied,
then pull them out to full extension. If the coffee machine
is installed above a "warmer drawer", use the top of the
latter as a reference for positioning the runners. In this
case, there will be no support surface.
x 16
GB27
x 2
Werbung
Kapitel
Inhaltsverzeichnis
