Safety Instructions For Circular Saw Blades; Original Accessories/Auxiliary Equipment; Before Use; Fitting/Changing The Saw Blade - Parkside PTSS 1200 C2 Originalbetriebsanleitung

Supplementary notes
■ Do not use any grinding discs.
■ Use only saw blades with diameters corres-
ponding to the label on the saw.
■ Always use the right saw blade for the material
being worked.
■ Use only saw blades with a speed marking
that corresponds to or is higher than the speed
specified for the power tool.
■ Saw blades that are intended for use on wood
or similar materials must comply with EN 847-1.
■ Do not allow the teeth of the saw blade to
overheat.
■ When sawing plastic, avoid melting the plastic.
■ Wear a dust mask when sawing.
■ Only use recommended saw blades.
■ Always wear hearing protection!
Safety instructions for circular
saw blades
Wear protective gloves!
Wear a dust mask!
Wear protective goggles!
Wear ear muffs!

Original accessories/auxiliary equipment

■ Only use the accessories and additional
equipment that are specified in the operating
instructions and compatible with the appli-
ance.
│ GB │ IE
■ 22

Before use

Fitting/changing the saw blade

Always remove the plug from the power socket
before working on the appliance.
NOTE
► Position the base plate for this operation on
the edge of a stable surface so that the saw
blade can be lowered.
1. Activate the safety lock-out
motor unit forwards a little way.
2. Open the clamping lever
Then push the motor unit
hear the lock click into place. Release the safety
lock-out . The movement of the motor unit is
blocked upward and downward.
3. The clamping screw/washer
in the cut-out .
14 b
4. Press the spindle lock button
engages) and use the hex key
the clamping screw/washer
5. Remove the saw blade
NOTE
► Ensure that the factory-fitted flange X stays
in place during installation and removal
(see fig. A).
Fig. A
6. To fit a saw blade
in reverse order.
WARNING!
► The direction of rotation of the saw blade
and the machine must match.
and push the
.
forward until you
is now located
14a
(until it
to release
.
14a
.
X
, carry out the above steps
PTSS 1200 C2