Die Grinder Pgs 500 A1; Introduction; Intended Use; Features - Parkside PGS 500 A1 Originalbetriebsanleitung

DIE GRINDER PGS 500 A1

Introduction

Congratulations on the purchase of your new appli-
ance . You have chosen a high-quality product . The
operating instructions are part of this product . They
contain important information about safety, usage
and disposal . Before using the product, please famil-
iarise yourself with all operating and safety instruc-
tions . Use the product only as described and for the
range of applications specified . Please also pass
these operating instructions on to any future owner .

Intended use

The appliance is intended for grinding and deburr-
ing metal with aluminous abrasives and work with
sanding belt bodies . It is furthermore intended for
brushing and polishing metal . Any other use of or
modification of the appliance is deemed contrary
to the intended use and carries the risk of serious
personal injury . Not for commercial use .

Features

Steplessly adjustable speed control
ON/OFF switch
Power cord
Ventilation slits
Tensioning nut
Collect chuck 6 mm (pre-assembled)
Spindle lock button
Collect chuck 3 .2 mm
Grinding stone
Assembly wrench

Package contents

1 die grinder PGS 500 A1
2 collet chucks
1 grinding stone
1 assembly wrench
1 plastic case
1 set of operating instructions
■ 26
│ GB│MT

Technical data

Rated power
consumption:
Rated voltage:
Rated speed:
Chuck suspension:
Intended shaft diameter max . Ø 6 mm
Clamping
Protection class:
NOTE
► Only use accessories designed for more
than 30,000 rpm.
Noise emission value:
Noise measurement value determined in
accordance with EN 60745 . The noise level of the
power tool rated A is typically the following:
Sound pressure level:
Uncertainty K:
Sound power level:
Uncertainty K:
Wear hearing protection!
Vibration emission value:
Total vibration values (vector total of three directions)
determined in accordance with EN 60745:
Vibration emission value: a
Uncertainty K = 1 .5 m/s
NOTE
► The vibration level specified in these instruc-
tions has been measured in accordance with
a standardised measuring procedure and
can be used for equipment comparisons . The
specified vibration emission value can also
be used to make an initial exposure estimate .
500 W
230 V ~ , 50 Hz (AC)
n 4,500–30,000 min
max . Ø 6 mm
min . 10 mm
II / (double insulation)
L = 78 .4 dB (A)
PA
K = 3 dB
PA
L = 89 .4 dB (A)
WA
K = 3 dB
WA
= 5 .301 m/s
2
h
2
PGS 500 A1
-1