Installation Procedure - Yamaha SPM-K8 Installationsanleitung

INSTALLATION PROCEDURE

Make sure to leave adequate ventilation space around the unit and follow the instructions below.
1 Attach the large wall mount bracket to the wall.
In order to secure the unit to the wall, you will need to attach the bracket to the wall first in a manner befitting the
structure and quality of the wall.
Choose a location where the wall can bear the weight of the whole unit.
Before installing the bracket, make sure of the size (see "DIMENSIONS" on the first page of this manual).
Installation example
Washer
(commercially
available)
Choose a secure wall or beam to fasten the screws. Do not install them into walls made of weak
material that can easily come off, such as mortar or plywood wall panels. Loose screws could cause
the projector to fall, resulting in personal injury.
2 Detach the metal apparatuses from the Sound Projector.
Detach the metal apparatuses from the rear left and right sides of the Sound Projector.
You need the detached screws in procedure 3. Be careful not to lose them.
Metal
apparatus
4mm Tapping Screw (commercially available)
In order to secure the unit to the wall, drive four (or more) tapping
screws from the outside through the holes in the wall mount bracket.
Installing directly
Installing into a dry
into a wall, etc.
wall
25mm or more 25mm or more
Beam, etc. Dry wall
INSTALLATION PROCEDURE
Metal
apparatus
E-3