Canon RS-CL07 Installationsanleitung Seite 21

Replacing the Lamp and Cleaning/Replacing the Air Filter
This Ceiling-mount Hanger allows you to replace the lamp and clean/replace the air fi lter without dismounting the
projector.
Before replacing the lamp or cleaning/replacing the air fi lter, be sure to turn off the projector and
unplug the power cord from the AC outlet and that the projector is cooled suffi ciently.
For details on how to replace the lamp and clean/replace the air fi lter, refer to the User's Manual
that came with the projector.
Caution
1 Hold the projector, and remove two wing
screws (A) and open the Base bracket
slowly.
2 Replace the lamp, or clean or replace the
air fi lter.
3 After completion of replacement of the
lamp or cleaning/replacement of the air
filter, lift up the projector, and close the
Base bracket then tighten the wing screw
(A).
Specifi cations
Horizontal projection angle
Adjustment
Vertical projection angle
rangee
Outer dimension of assembly
(excluding projection)
Weight (Ceiling-mount Hanger only)
10
Screen slant angle
222.7 mm (W）x 281.5 mm (D）x 175.8 mm (H)
RS-CL07
1
A
A
RS-CL10
1
A
A
RS-CL07
5° leftward or rightward
5° upward or 20° downward
± 5 °
0.7' (W) x 0.9' (D) x 0.6' (H)
4.1 kg/9.1 lbs
Lamp cover
Filter cover
Lamp cover
RS-CL10
5° leftward or rightward
5° upward or 20° downward
± 5 °
310.5 mm (W) x 276.2 mm (D) x 178.2 mm (H)
1.0' (W) x 0.9' (D) x 0.6' (H)
4.1 kg/9.1 lbs
Filter cover