Transferring Pictures To A Computer - Parkside PKIK 4.3 A1 Bedienungs- Und Sicherheitshinweise

6.5.11 Transferring pictures to a computer

You can use the USB cable [F] supplied to connect the borescope to a
computer and transfer your pictures to it. Proceed as follows:
CAUTION! Loss of data
Be careful when renaming any folders and files. Do NOT try to
change the folder or file names stored on the device from the
computer or you may not be able to read any files contained
here on your borescope.
Once you have copied your files or folders to the computer, you
can rename or edit them on the computer.
Unplug the mass storage device via the operating system's
safely remove hardware feature before disconnecting the USB
cable [F] from the borescope and the computer.
The manufacturer accepts no liability for any loss of data!
•
Plug the USB cable [F] into the Micro USB port [9] and into a free USB
port on your powered-on computer.
•
If the borescope was switched off, it will switch on automatically. A USB
cable symbol appears on the display [1] .
•
The computer will now set up a removable disk that can be used to
access your recordings.
•
Now you can transfer the pictures to your computer.
•
After you have finished transferring the pictures to your computer, safely
unplug the removable storage media using the corresponding function
of your operating system.
•
Unplug the USB cable [F] from the borescope and the computer.
•
The borescope switches automatically off after a few seconds.
PARKSIDE PKIK 4.3 A1
English - 17