Operation; Fitting/Changing The Saw Blade; Rip Fence; Connecting The Sawdust Extraction Device - Parkside PHKSA 20-Li A2 Originalbetriebsanleitung

Operation

Fitting/changing the saw blade

Always remove the battery pack before changing
the saw blade !
1. Set the cutting depth (using the locking screw
) to the minimum position, 0 mm.
2. Swing the blade guard
release lever and put the appliance down.
3. Press the spindle lock button
engages) and use the hex key
clamping screw . Now remove the clamping
screw and the clamping flange
fig. A).
Fig. A: Changing the saw blade
4. Remove the saw blade
5. Fitting a saw blade
reverse order.
6. Press the spindle lock button
and use the hex key
screw/washer .
WARNING!
► The arrow on the saw blade
correspond to the arrow showing the
direction of rotation
shown on the blade guard
■ Ensure that the saw blade
rotational speed of the tool.
│ GB │ MT
■ 58
back using the
(until it
to release the
(see also
.
is carried out in the
(until it engages)
to tighten the clamping
must
(running direction
).
is suitable for the

Rip fence

♦ Undo the wing screw
fence into the rip fence slot
♦ Set the desired cut width with the help of the
scale on the rip fence
base plate (see also fig. B).
The right recess in the base plate is for a cutting
angle of 0°. The left-hand recess in the base
plate is for a cutting angle of 45°.
Fig. B: Cutting width 3 cm
♦ Retighten the wing screw
Connecting the sawdust extraction
device
♦ Attach the adapter for dust extraction
chip ejector .
Optional, depending on the diameter of the
dust and sawdust extraction.
♦ Connect an approved dust and chip extraction
device.
NOTE
► When sawing wood or other materials that
create dusts that are hazardous to health,
always connect the appliance to a suitable,
certified suction appliance.
and insert the rip
.
and the cut out in the
.
to the
PHKSA 20-Li A2