Checking The Chain Brake; Basic Working Procedures When Felling Trees - Parkside PKSA 20-Li A1 Originalbetriebsanleitung

♦ If you can see this oil, the tool is operating
correctly.
♦ If you cannot see any oil, clean the oil dis penser
or have the tool repaired by our Customer
Service.
♦ To clean the oil dispenser
residues using a brush or cloth.

Checking the chain brake

WARNING!
► You must check the chain brake before every
use.
■ The chain brake stops the saw chain in the
event of a kickback.
♦ Make sure, that the front hand guard
of dirt and moves freely.
♦ With the tool switched on, press the front hand
guard forwards until it clicks into place.
♦ Pull in the ON/OFF switch
go (full throttle).
The saw chain should not move.
WARNING!
► High revs over a long period with the chain
brake engaged will damage the motor and
the chain drive.
► If the saw chain
contact Customer Service.
PKSA 20-Li A1
, wipe away any
is free
as far as it will
does move, however,
Basic working procedures
when felling trees
RISK OF INJURY!
► Sawing and felling work as well as all
associated tasks may only be carried out by
properly trained operators.
NOTE
► Note your country's laws regarding felling
work and contact the appropriate authority
for more information.
■ Make sure that no one can be injured by falling
branches and trees.
■ Only the required personnel should be in the
working area.
■ Keep the area around the trunk free and tidy to
ensure secure footing for the operators.
■ Keep all escape routes free and tidy to ensure
that the working area can be evacuated quickly.
■ Do not carry out any felling work in strong
wind, poor weather or bad visibility.
■ Keep a distance of at least 2 1/2 tree lengths
from next working area.
Use and handling
■ Never start the tool before the guide rail
saw chain and sprocket cover
fitted correctly.
■ Do not cut any wood that is lying on the ground
and do not attempt to saw roots that are pro-
truding from the soil. Never allow the saw chain
to come into contace with the soil, as this
could blunt the saw chain
■ If the tool accidentally comes into contact with
a solid object, turn off the motor immediately
and inspect the tool for damage.
■ Service the tool carefully. Check for misalign-
ment or binding of moving parts, breakage of
parts and any other damage that may impair
the tool's operation. If damaged, have the pow-
er tool repaired before use. Many accidents are
caused by poorly maintained tools.
,
have been
.
GB │ MT │
97 ■