Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
gauge
(see "Building up the operat-
4
ing pressure").
Pull the safety valve
as it will go to release the residual pres-
sure in the container
Setting the spray nozzle
To adjust the the spray nozzle
as follow:
To generate a wider spray zone, turn
the tip of the spray nozzle
as far as it will go.
To create a concentrated jet, turn the tip
of the spray nozzle
anti-clockwise.
Cleaning and care
If the nozzle seems to be blocked, do
not try to blow it free with your mouth.
Note: Clean the pressure sprayer after
each use! Empty the bottle after each use.
Clean the pressure sprayer
Unscrew the spray nozzle
Clean the spray nozzle
water.
If the spray nozzle
clean it by pushing a needle through it.
Flush through the pressure sprayer,
pipes and tubes with water.
Clean the surfaces of the product with
a moist cloth.
upwards as far
3
.
5
proceed
7
clockwise
7
a quarter turn
7
.
7
under running
7
is clogged,
7
Clean the suction hose
Clean the suction hose
Loosen the union nut of the suction hose
on the container
9
Pull the suction hose
tank
.
5
Remove the filter, clean the filter and
suction hose
12
After cleaning, plug in the filter and insert
the suction hose
on the tank
.
5
Tighten the union nut
Store the pressure
sprayer
Release any residual pressure still present
in the container after use. To do this,
pull the safety valve button upwards
until you can no longer hear the hiss of
escaping air.
Thoroughly clean the device and allow
it to dry before you put it away for the
winter. This will avoid frost damage.
Clean the pressure sprayer before storing
it away.
Remove any leftover spray product from
the tank and the pipes.
Store the pressure sprayer in a dry,
dust-free place.
Troubleshooting
If the measures listed below are not success-
ful, contact the manufacturer.
= Fault
= Potential causes
= Remedies
as follows:
12
.
5
out of the
12
under running water.
back in its opening
12
hand-tight.
9
GB/IE
17
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
