Bringing Into Use; Attaching The Spray Tube; Filling The Pressure Sprayer Tank; Building Up The Operating Pressure - Parkside HG05659 Bedienungs- Und Sicherheitshinweise

Pull the safety valve
You must be able to hear the pressure
escaping.

Bringing into use

Attaching the spray tube

(Fig. B)
Turn the union nut
release it from the handle
spray tube into the handle
8
far as it will go.
Tighten the union nut
clockwise.
Filling the pressure
sprayer tank (Fig. D)
Note: Before using the product, check to
see that it is in good condition and free of
defects.
Press the pump handle
and turn it anticlockwise.
Note: Before you open the tank, pull
the safety valve
any residual pressure still present in the
container .
5
Draw the pump
.
5
Now fill the tank.
Note: Fill the tank with only the
amount of liquid that you actually need
for that particular spraying session (not
more than 5 l).
Place the pump
tainer and turn the pump handle
5
clockwise as far as it will go.
16 GB/IE
up to the stop.
3
anticlockwise to
10
. Push the
11
as
11
by turning it
10
downwards
1
upwards to release
3
out of the container
2
back into the con-
2
Building up the operating
pressure
Move the pump handle
until the pressure sprayer has been
pumped up to a pressure not exceeding
the maximum permissible operating
pressure of 2.5 bar. To ensure this value
is not exceeded, monitor the pressure
gauge
4
Note: If the pressure of the air in the
container
sure is automatically released through
the safety valve
Press the pump handle
into the recesses.
Now take the spray tube
holder.

Spraying

Hang the pressure sprayer over your
shoulder by the carrying strap
Note: Ensure that the pressure sprayer
is always kept upright. Only when held
in this orientation will the sprayer work
properly.
Hold the spray tube firmly by the han-
dle and direct the adjustable spray
11
nozzle
7
Press the trigger
process.
Release the trigger
spraying process.
Note: When the pressure in the con-
tainer is no longer sufficient to spray,
5
pump the container
pressure again up to but not exceeding
1
the maximum permissible operating
pressure of 2.5 bar. You can check the
operating pressure using the pressure
up and down
1
during the pumping process.
exceeds 2.5 bar, the pres-
5
.
3
downwards
1
out of the
8
e.g. at a plant.
to start the spraying
13
to stop the
13
to increase the
5
.
6