Setting The Digital Output; Lpcm Output; Cd Upsampling - Yamaha dvd s550 Bedienungsanleitung

Setup Menu

Setting the Digital output

The options included in Digital Audio are:
'Digital Output' and 'LPCM Output'.
1 In 'AUDIO SETUP PAGE', press 34 to
highlight {DIGITAL AUDIO}, then press 2.
2 Press the 34 to highlight an option.
3 Enter its submenu by pressing 2.
4 Move the cursor by pressing the 34 to
highlight the selected item.
DIGITAL OUTPUT
Set the Digital output according to your
optional audio equipment connection.
OFF
Turn off the digital output.
ALL
If you have connected your DIGITAL
AUDIO OUT to a multi-channel decoder/
receiver.
PCM ONLY
Only if your receiver is not capable of
decoding multi-channel audio.

LPCM OUTPUT

If you connect the DVD Player to a PCM
compatible receiver via the digital
terminals, such as coaxial or optical etc.,
you may need to adjust 'LPCM Output'.
Discs are recorded at a certain sampling
rate. The higher the sampling rate, the
better the sound quality.
48K
Playback a disc recorded at the sampling
rate of 48kHz. 96kHz (if available on disc)
PCM data stream will be converted to
48kHz.
TIPS: To return to the previous menu, press 1.
To remove the menu, press SETUP.
20
96K
Playback a disc recorded at the sampling
rate of 96kHz. If the 96kHz disc is copy
protected, the digital output will be muted
to comply with the standards.

CD Upsampling

This feature allows you to convert your
music CD to a higher sampling rate using
sophisticated digital signal processing for
better sound quality. If you have activated
the upsampling, the player will
automatically switch to stereo mode.
1 In 'AUDIO SETUP PAGE', press 34 to
highlight {CD UPSAMPLING}, then press
2.
OFF
Select this to disable CD-upsampling.
88.2 kHz (X2)
Select this to convert the sampling rate of
the CDs twice higher than the original.
176.4 kHz (X4)
Select this to convert the sampling rate of
the CDs four times higher than the
original.
2 Press 34 to select a setting, then press
ENTER/OK to confirm your selection.
Note:
– This setting is only applicable for the signals
output from the analog jacks.