Troubleshooting; Possible Cause - Parkside PKS 1500 B3 Bedienungs- Und Sicherheitshinweise

15. Troubleshooting

Fault

Possible cause

Motor does not work Motor, cable or plug defective, fuses burnt
The motor starts up slowly Voltage too low, coils damaged, capacitor burnt
and does not reach oper-
ating speed.
Motor makes excessive Coils damaged, motor defective
noise
The motor does not reach Circuits in the network are overloaded (lamps,
its full power. other motors, etc.)
Motor overheats easily. Overloading of the motor, insufficient cooling of
the motor
Saw cut is rough or wavy Saw blade dull, tooth shape not appropriate for
the material thickness
Workpiece pulls away Excessive cutting pressure and/or saw blade not
and/or splinters suitable for use
Remedy
Arrange for inspection of the machine by a specialist.
Never repair the motor yourself. Danger!
Check fuses and replace as necessary
Contact the utility provider to check the voltage.
Arrange for inspection of the motor by a specialist. Ar-
range for replacement of the capacitor by a specialist
Arrange for inspection of the motor by a specialist
Do not use any other equipment or motors on the same
circuit
Avoid overloading the motor while cutting, remove dust
from the motor in order to ensure optimal cooling of the
motor
Re-sharpen saw blade and/or use suitable saw blade
Insert suitable saw blade
GB 13