Quitting The System - Pioneer DDJ-SZ Bedienungsanleitung

Playing tracks and outputting the sound
The following describes the procedure for outputting the channel 1
sound as an example.
Set the volume of the devices (power amplifier, powered speakers,
etc.) connected to the [MASTER OUT 1] and [MASTER OUT 2]
terminals to an appropriate level. Note that loud sound will be output
if the volume is set too high.
4
5
6
7
8
9
a
b
3 CD, USB selector switch
4 TRIM control
5 ISO (HI, MID, LOW) controls
6 Headphones CUE button
7 Channel fader
8 HEADPHONES MIXING control
9 HEADPHONES LEVEL control
a Crossfader assign selector switch
b Crossfader
c MASTER LEVEL control
d MASTER CUE button
e BOOTH MONITOR control
f CROSS FADER CURVE selector switch
14
En
1 Set the positions of the controls, etc., as shown below.
Names of controls, etc.
MASTER LEVEL control
CD, USB selector switch
TRIM control
ISO (HI, MID, LOW) controls
Channel fader
Crossfader assign selector switch
2 Press the [
c
d
e
3 Move the channel fader away from you.
4 Turn the [TRIM] control.
Adjust [TRIM] so that the orange indicator on the channel level indicator
lights at the peak level.
5 Turn the [MASTER LEVEL] control to adjust the audio
level of the speakers.
Adjust the sound level output from the [MASTER OUT 1] and [MASTER
OUT 2] terminals to an appropriate level.
Monitoring sound with headphones
Set the positions of the controls, etc., as shown below.
f
Names of controls, etc.
HEADPHONES MIXING control
HEADPHONES LEVEL control
1 Press the headphones [CUE] button for the channel 1.
2 Turn the [HEADPHONES LEVEL] control.
Adjust the sound level output from the headphones to an appropriate
level.
This unit and the Serato DJ software include a variety of functions
enabling individualistic DJ performances. For details on the respective
functions, see the Serato DJ software manual.
The Serato DJ software manual can be downloaded from "Serato.com".
For details, see Downloading the Serato DJ software manual (p. 5).

Quitting the system

1 Quit [Serato DJ].
When the software is closed, a message for confirming that you want to
close it appears on the computer's screen. Click [Yes] to close.
2 Press the [ ] switch on this unit's rear panel to set
this unit's power to standby.
3 Disconnect the USB cable from your computer.
] button to play the track.
Note
Position
Turned fully counterclockwise
[USB] position
Turned fully counterclockwise
Center
Moved forward
[THRU] position
Position
Center
Turned fully counterclockwise