First Use; Switching On And Off; Infinitely Adjustable Speed Setting; Preselecting The Rotation Speed - Parkside PSBM 850 Bedienungs- Und Sicherheitshinweise

drill chuck you can use the tool. The spindle
8
lock releases automatically when the motor starts.

First use

Q
The mains voltage at the mains socket must match
that shown on the rating plate on the device. Devic-
es marked with 230 V can also be operated at 220 V.

Switching on and off

Q
When operating the hammer-action drill you can
select between intermittent or continuous operation
mode. Use intermittent operation mode for shorter
drilling jobs and continuous operation mode for
longer drilling jobs. In either mode the device func-
tions as follows:
To switch on intermittent operation mode:
j
Press the on / oFF switch
To switch off intermittent operation mode:
j
Release the on / oFF switch
To switch on continuous operation mode:
j
Press the on / oFF switch
and press the lock switch
To switch off continuous operation mode:
j
Press and then release the on / oFF switch
Infinitely adjustable speed
Q
setting
The on / oFF switch
2
control.
j
Pressing the on / oFF switch
speed.

Preselecting the rotation speed

Q
You can pre-select the required speed in ratchet
steps (A-F) using the speed preselector wheel
.
2
.
2
, keep it pressed
2
.
3
2
has a variable speed
increases the
2
4
j
The most suitable speed depends on the mate-
rial involved. We recommend that you carry
out a few practical tests beforehand.
Tip: You will always find these two basic guide-
lines helpful:
1. Large drill diameter = lower speed whilst
smaller drill diameter = higher speed
2. Hard material = lower speed
Selecting the direction of
Q
rotation
cAUTIOn! only change the position of the rota-
tion direction switch
to a standstill.
j
Set the direction in which you wish the drill to
rotate by using the rotation direction switch

Selecting the gear

Q
cAUTIOn! The gear selector switch
be moved after the device has come to a standstill.
j
Select the speed range using the gear selector
switch :
6
1 = low speed range
. 2 = high speed range
Switching between drilling /
Q
hammer-action
note: The drill / hammer-action switch
only be moved after the device has come to a
standstill.
.
Before first use / First use
after the device has come
5
must only
6
1
GB/MT
.
5
must
31