Blaupunkt Arrifana 12 Bedienungsanleitung Seite 15

A12C
SWITCHING THE DEVICE ON
1. Once you have completely installed the device as described in the chapter "Assembly
and Installation" you can switch it on.
2. Press the Power button (25). The device switches on.
3. Select the desired operating mode.
The device switches off automatically when the condensation tank is full. FL appears in the
segment display (29) and an accoustic signal is emitted.
COOL MODE
1. In cool mode the room will be cooled down to a certain preselected temperature. The fan
speed can be set as required. Press the Mode button (26) until the cooling mode
indicator (20) appears on the control panel.
2. Press the UP button (19) for increasing or the DOWN button (23) for reducing the
temperature to set the desired target temperature. The target temperature is indicated
on the display (29).
DRY MODE
1. In dry mode the humidity level in the room is reduced. The temperature cannot be
adjusted and the fan runs at the lowest speed level.
2. If you use the device for an extended period of time or you don't want to empty the tank
all the time, you can connect a condensation drain hose to the condensate water drain.
3. The compressor only starts at a room temperature of ≥ 17 °C.
4. Press the Mode button (26) until the dry mode indicator (22) appears on the control
panel. The current room temperature is indicated on the segment display (29).
5. If the device is operated in a very humid environment, the accumulating condensate
must be drained at regular intervals.
FAN MODE
1. In Fan mode the room air is circulated, it will neither be cooled nor dehumidified.
2. Press the Mode button (26) until the fan mode indicator (21) appears on the control
panel.
3. Press the Fan button (18) to set the desired fan speed. The selected fan speed (27) is
displayed. The current room temperature is indicated on the segment display (29).
www.blaupunkt.com
15