Installation Instructions - Blaupunkt MBS07E Bedienungsanleitung

INSTALLATION INSTRUCTIONS

EXHAUSTING HOT AIR
In the Cool Mode the appliance must be placed close to a
window or opening so that the warm exhaust air can be
ducked outside.
First position unit on a flat floor and make sure there's a
minimum of 17.7" (45cm) clearance around the unit, and is
within the vicinity of a single circuit outlet power source.
1. Extend either side of the hose (Fig. 1)
2. Screw the hose inlet (Fig.2).
3. Screw it to the hose inlet (Fig.3).
4. Install the hose inlet into the unit (Fig.4).
5. Affix the hose outlet into the window slider kit and seal.
(Fig.5 &6).
Slide into
The window slider kit has been designed to fit most standard vertical and horizontal
window applications, however, it may be necessary for you to modify some aspects of the
installation procedures for certain types of windows. The window slider kit can be fastened
with screws.
Note: If the window opening is less than the minimum length of the window slider kit, cut
the end without the hold in it short enough to fit in the
window opening. Never cut out the hole in window slider
kit.
Vertical
Window
Window slider
Fig.5
Fig.4
www.blaupunkt.com
Extend the side of hose
Horizontal
Window
Window slider
Fig.6
Cut on opposite
side of hole.
Fig. 1
Fig. 2
Fig. 3
14