Panasonic ER214 Bedienungsanleitung Seite 8

2 How to charge the
battery
Using the rechargeable battery
Charge the battery by plugging the
Trimmer into an AC source using the
cord. The switch should be set to "0-
charge" during charging. Charge the
trimmer fully for 24 hours before us-
ing it for the first time, or when it has
not been used for more than 6
months. For normal use, charge it
fully for 1 hour. A full charge will give
40 minutes of use.
• The lamp lights while the battery is
being charged and flashes when
the charging is completed.
• The trimmer will become warm
while the battery is being charged,
but this is not a malfunction.
Using an AC power source
Plug the Trimmer into an AC power
source using the cord with the switch
set to "0-charge". Wait about 1
minute, then switch the Trimmer on.
After use, return the switch to the "0-
charge" position.
3 Adjusting the trimming
height
1 Attach the trimming height attach-
ment (a) to the body.
2 The trimming height can be ad-
justed in 12 steps (b).
3 Press the trimming height adjust-
ment switch (c) and adjust to the
desired trimming height.
OS01L015_ER214-ER216_E
Indicator
1
•
3
•
5
•
7
•
9
•
11
•
4 Leveling the beard
height
1 Adjust the trimming height.
2 Trim with upward movements.
(Hold the comb part of the trim-
ming height attachment against
your skin in the opposite direction
to the hair growth.)
When trimming a lot of beard, the
beard cuttings accumulate inside the
trimming height attachment. If this
happens, empty the attachment
when necessary.
5 Shaping the beard and
aligning the edges
Remove the trimming height attach-
ment from the body.
Trim with the blade at a 90° angle to
the beard.
(Trim a little at a time in order to pre-
vent trimming too much.)
8
8
Beard Length
2.0 mm
3.0 mm
4.5 mm
6.0 mm
7.5 mm
9.0 mm
10.5 mm
12.0 mm
13.5 mm
15.0 mm
16.5 mm
18.0 mm
1/17/02, 4:43 PM