Filling The Cleaning Fluid Container; Use; Maintenance And Cleaning - Parkside PDRP 6.2 B2 Originalbetriebsanleitung

Filling the cleaning fluid container

♦ Fill the cleaning fluid container
the desired mark .
NOTE
♦ The maximum water temperature is 30 °C .
Please observe the instructions of the cleaning
agent manufacturer . If a lower temperature is
indicated, use only this temperature .
If necessary, you can add water-soluble,
non-foaming cleaning agents . For the exact
mixing ratio, follow the instructions of the
cleaning agent manufacturer .
♦ Do not use acidic, alkaline or easily flammable
cleaning agents .
♦ The compressed air cleaning gun atomizes
the cleaning fluids into micro-fine droplets .

Use

♦ The surface to be cleaned must be roughly
cleaned before use .
♦ Turn the valve to the vertical position in order
to switch on the cleaning fluid from the cleaning
fluid tank .
The valve is infinitely variable, so that the
amount of cleaning fluid is increased or re-
duced, depending on the setting of the
valve .
♦ Keep the compressed air cleaning gun at a
distance of 1–3 cm from the surface to be
cleaned .
♦ Press and hold the trigger
compressed air cleaning gun .
♦ In order to achieve an optimal result, move the
brush of the compressed air cleaning gun in
smooth, circular movements over the surface to
be cleaned .
♦ To finish working, release the trigger
PDRP 6.2 B2
♦
with water to
♦

Maintenance and cleaning

to activate the
■
■
■
.
After finishing the work, wipe the surface dry,
switch off the compressor and disconnect the
compressed air hose from the compressed air
cleaning gun .
Afterwards, unscrew the cleaning fluid tank
from the compressed air cleaning gun and
dispose of the contents in an environmentally
friendly manner .
WARNING! RISK OF INJURY!
Disconnect the appliance from
the compressed air supply.
ATTENTION!
► Before maintenance, clean off any hazardous
substances that may have accumulated on
the tool (due to working processes) . Avoid all
skin contact with these substances . If the skin
comes into contact with hazardous dusts, this
can lead to severe dermatitis .
► The dust and vapours produced by using
the appliance can be hazardous to health
(e .g . cause cancer, birth defects, asthma
and/or dermatitis); it is essential to carry out
a risk assessment in respect of these risks
and to implement corresponding regulatory
mechanisms .
NOTE
► The following points must be observed
to ensure that the cleaning gun functions
perfectly and has a long service life:
Use only the genuine replacement parts
re commended by the manufacturer, otherwise
you could put users at risk . In doubt, contact
the Service Centre .
Clean the tool with a soft, dry cloth only .
Never use sharp or abrasive cleaning agents .
GB │ IE │ 17 ■