Technical Data - Blaupunkt SAFEDRIVE SDC 2.0 Bedienungsanleitung

Warranty | Service | Replace Battery | Technical data | Troubleshooting
Warranty
For products purchased within the European Union,
we provide a manufacturer's warranty. For devices
purchased outside the European Union, the warranty
conditions issued by our respective national represen-
tative apply.
The warranty conditions can be viewed at
www.blaupunkt.com, if no further information is given
here, the customary national legal provisions apply.
Service
Should you ever need a repair service, please contact
your Blaupunkt dealer. Further information on service
partners in your country can be found at www.blau-
punkt.com.
Replace Battery
If you operate the controller with a battery, it must be
replaced every 2-12 months (depending on usage).
Only use the battery type CR2032 / 3V:
Turn the battery compartment cover on the back of
the controller in the direction of the visible „OPEN" ar-
row, using a straightened paper clip or needle to insert
it into the small hole in the lid, then carefully lift it off
without force.
Gently pry out the battery, avoid touching the contacts
or tabs.
Insert the new battery first on the side with the con-
tacts (+ must be visible on the inserted battery) and
then gently push down on the opposite side until it
clicks into place.
Now replace the battery compartment cover and close
it.

Technical Data

Range
(Distance between
transmitter and receiver,
depends on environment):
Power supply
Remote controller:
Interface:
Quiescent current:
about 5- 10m
3V, CR2032/ 10.5 -14.4 V
10.5 -14.4 V
< 1mA
Troubleshooting
Below you will find some error pictures and their possi-
ble solution. If you still have problems with the device,
contact your dealer or Blaupunkt Service. Please have
the installation checked or carried out by a specialist in
case of problems. Much of the problems that may arise
can be attributed to connection and operator errors.
• No function when pressing a key:
Please check the battery / power supply of the cont-
roller.
Please check the power supply of the interface.
Please check the cabling / connections.
• No or wrong function when pressing button(s):
Please re-learn the corresponding button(s) via the
menu in your car radio, please refer to the instructions
of your car radio.
• Rotary encoder does not work as desired/ programming
Move the rotary encoder ⑨ during the teach-in pro-
not possible at all:
cess only a step / click or a specific number of steps,
be necessary to program the volume to the ⑧ keys if
then check the function. Depending on the radio, it may
the encoder signals are not processed correctly. Then
use the rotary encoder for other functions such as title
jump / station change, etc..
Please try to change controller to the teach-in mode
(see chapter "Programming")
• Remote control does not work after switching on the car
radio again and must always be reprogrammed:
Please check whether the radio is properly connected
to permanent power (battery).
11