Before Use; Removing/Charging/Inserting The Battery Pack; Use; Fitting/Changing The Saw Blade - Parkside PSTKA 12 A2 Originalbetriebsanleitung

Before use

Removing/charging/inserting the
battery pack
CAUTION!
► Always unplug the appliance before you
remove the battery pack
the battery pack to the charger.
NOTE
► The battery pack is supplied partially charged.
Before first use, charge the battery pack in
the charger for at least 1 hour. This guarantees
full battery power. You can charge the lithium-
ion battery at any time without shortening
its service life. Interrupting the charging
process does not damage the batterybattery
pack.
► If the battery pack overheats during opera-
tion, charging is not possible. Allow it to cool
down first.
► Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level is
between 50% and 80%. The storage climate
should be cool and dry and the ambient tem-
perature should be between 0°C and 50°C.
1. To remove the battery pack
button and pull the battery pack
appliance.
2. Insert the battery pack
charger .
3. Insert the mains plug into the socket. The control
LED lights up red.
4. The green charge status indicator LED
cates that the charging process is complete and
the battery pack
5. Insert the battery pack
PSTKA 12 A2
from or connect
, press the release
out of the
into the high-speed
indi-
is ready.
back into the appliance.

Use

Fitting/changing the saw blade

WARNING!
► Wear protective gloves! There is a risk of
injury from the sharp cutting teeth.
► Always remove the battery pack before car-
rying out any work on the appliance.
♦ Remove the blade guard
♦ Turn the quick-release chuck
this position.
♦ Push the required saw blade into the quick-
release chuck as far as the stop.
♦ Let go of the quick-release chuck
returns to its initial position. The saw blade is
now locked.
♦ Check whether the saw blade is firmly fitted.
■ ATTENTION! The saw blade teeth must face the
front (see fold-out page)!
♦ Replace the blade guard

Fitting the rip fence

The rip fence can be fitted on the left or right of
the appliance.
♦ Undo both of the clamping screws on the inser-
tion openings .
♦ Push the rip fence
.
♦ Retighten the two locking screws.

Connecting the sawdust extractor

♦ Push the reducer
until it is firmly in place.
♦ Attach an approved dust and sawdust extractor
to the reducer or directly to the extraction
nozzle .
.
and hold it in
so that it
on the appliance.
into the insertion openings
into the extraction nozzle
GB │ IE │
25 ■