Safety Information; Technical Speciications; Initial Operation - Parkside PHDVS 6 A1 Originalbetriebsanleitung

Safety information

Also observe the safety instruction
for your high-pressure washer.
Pressure washers can be dan-
gerous if used incorrectly. Do
not direct the jet at people, ani-
mals, live electrical equipment
or the equipment itself.
• Be aware of the increased risk of trip-
ping when using your pressure washer
with the high pressure extension hose.
• Do not run over, squash or crease the
high pressure extension hose. There is
a risk of damage and therefore injury
to you.
• Use only original accessories and do
not carry out conversion work on the
equipment.
• Store the equipment in a frost-proof
room.

Technical speciications

PHDVS 6 A1
High-pressure extension hose:
Length ............................................. 6 m
Suitable for high-pressure washer with the
following performance:
Rated pressure (p) ........ 110 bar / 11 MPa
Operating pressure (p max)
.................................160 bar / 16 MPa
Intake temperature (T max) 60 °C / 140 °F

Initial Operation

Series
PHD 150 E4, PHD 150 F4,
PHD 150 G4
PHD 135 A1, PHD 135 B1
PHD 110 A1.
Quick-connect adapter (8).
Connecting to PARKSIDE high-pressure
cleaners (with quick-connect connection
system):
1. Insert the high-pressure extension
hose (1) on the quick-connect
hose connection (2) into the
connection of the spray gun (10)
until it audibly clicks into place.
2. Connect the high-pressure exten-
sion hose (1) to the high-pressure
hose (11) of your PARKSIDE
high-pressure cleaner. You
can hear it click into place.
3. Check the connections by pulling
on the high-pressure extension
hose (1).
4. To release the connections, press
the release button (9) on the
quick-connect adapter (8) and
the release button (12) on
the spray gun (13) and pull off
the high-pressure extension hose
(1).
GB MT
25