Herunterladen Inhalt Inhalt Diese Seite drucken

Kickback (See Fold-Out Page, Fig. F); Drawing In (See Fold-Out Page, Fig. G); Working Safely; Cleaning And Maintenance - Parkside PKSA 20-Li A1 Originalbetriebsanleitung

Akku-kettensäge
Vorschau ausblenden Andere Handbücher für PKSA 20-Li A1:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Trunk is bent downwards
Start by making a relief cut 1 (approx. 1/3 of
the trunk diameter) on the push side (see fold-
out page, fig. H).
Then make a separating cut 2 (approx. 2/3 of
the trunk diameter) on the pull side (see fold-out
page, fig. H).
Trunk is bent upwards
Start by making a relief cut 1 (approx. 1/3 of
the trunk diameter) on the push side (see fold-
out page, fig. H).
Then make a separating cut 2 (approx. 2/3 of
the trunk diameter) on the pull side (see fold-out
page, fig. H).
Kickback (see fold-out page, fig. F)
If the saw chain
the guide rail
, the chainsaw can kick back
violently towards the operator.
Drawing in (see fold-out page, fig. G)
If the saw chain
the guide rail
, the rail can jerk violently away
from the operator (see fold-out page, fig. H).

Working safely

Keep the tool in good working order to prevent
injury.
If the tool has been dropped, check for signifi-
cant damage or defects.
Do not use the tool while standing on a ladder
or with unsteady footing.
Do not be tempted into making a poorly con-
sidered cut.
You could endanger yourself and others.
Change your working position regularly. Using
the tool for a long time can lead to vibration-re-
lated circulation disorders of the hands. You can
extend the usage duration by using appropriate
gloves or by taking regular breaks. Note that
any personal predisposition to poor blood
circulation, low external temperatures or large
prehensile forces can reduce the usage period.
PKSA 20-Li A1
jams on the upper edge of
jams on the lower edge of

Cleaning and maintenance

WARNING! RISK OF INJURY! Always
switch the tool off and remove the
battery before carrying out any work
on the tool.
The tool must always be kept clean, dry and
free from oil or grease.
Never allow liquids to get into the tool.
Use a soft, dry cloth to clean the housing. Nev-
er use petrol, solvents or cleansers which can
damage plastic.
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level is
between 50% and 80%. The optimum storage
environment is cool and dry.
NOTE
Replacement parts not listed (such as carbon
brushes, switches) can be ordered via our
service hotline.
NOTE
Clean the tool thoroughly after every use.
Carry out the cleaning and maintenance
work only as described in these instructions.
Any more extensive work has to be carried
out by specialist personnel.
Maintenance work must be carried out regu-
larly (see section "Maintenance intervals").

Cleaning the tool

Keep all protective equipment, air vents and
the housing as free of dust and dirt as possible.
Blow it out with low-pressure compressed air.
Clean the tool regularly with a damp cloth and
a mild detergent. Make sure that no water can
penetrate into the interior of the tool.
GB │ IE
 43

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis