Advice On Use - Parkside PWS 125 A1 Bedienungs- Und Sicherheitshinweise

E nsure that any spacers supplied and
required for the use of certain abrasive
consumables and tools are installed.
D o not use separate reducing bushes
or adapters in order to make grinding
discs with a larger bore fit.
W hen using abrasive consumables
and tools with a threaded insert make
sure that the tread is long enough for
the spindle length. Otherwise the grinding
discs could become detached from the device
and result in injury and / or damage to property.
D o not allow the end of the spindle
to contact the base of the hole in the
abrasive consumable.
D o not work in areas where there may
be concealed electricity cables or gas
or water pipes. Use a suitable detector
or ask your local utility service pro-
viders. Contact with electricity cables can
lead to fire or electric shock. Damaging a gas
pipe can lead to an explosion. Penetration of a
water pipe can lead to property damage or to
electric shock.
NOxIOUS FUMES!
Working with harmful / noxious dusts represents
a risk to the health of the person operating the
device and to anyone near the work area.
F or longer periods of cutting or grind-
ing metal or stone materials which
give rise to dusts that are hazardous
to health, the device must be connected
to a suitable external dust extraction
device.
E nsure that there is adequate ventila-
tion when working on plastic, paint,
varnish etc.
D o not soak the materials or the sur-
face you are about to work on with
liquids containing solvents.
D ANGER OF INjURy! Wear close-fitting
clothing and keep long hair inside a
hairnet or suitable headwear.
F or safety reasons this device must
always be used with the auxiliary
handle in place.
4
T he adjustable disc guard cover
always be in place when working with
General safety advice for electrical power tools
roughing, grinding or cutting discs.
Otherwise there could be danger of injury.
U se the vacuum dust extraction facility
if your work generates high amounts
of dust. Use suction devices particular-
ly approved for the purpose.
U se permitted consumables and tools
only. Check that the speed given on the
discs is greater or equal to the rated
speed of the device.
T ake note of the direction of rotation
and always hold the device in such a
way that the sparks and grinding de-
bris are thrown away from your body.
Otherwise there could be danger of injury.
M ake sure that the dimensions of the
disc are suitable for the device and
that the disc is of a type that fits prop-
erly on to the mounting flange

Advice on use

Q
Note! Discs must be used only for their recom-
mended purposes, otherwise they could disintegrate,
become damaged or cause accidents.
Roughing (see Fig. G):
Never use cutting discs for
roughing or grinding!
M ove the angle grinder using even
pressure to and fro over the workpiece.
H old the roughing or grinding disc at
a flat angle to the workpiece when
working on a soft material. Use a
slightly steeper angle for harder ma-
terials.
Disc-cutting (see Figs. E, F):
Never use roughing or
grinding discs for cutting!
O nly use certified fibre-reinforced cut-
ting or grinding discs approved for use at
circumferential speeds of not less than 80 m / s.
must CAUTION! The disc continues to rotate after
5
the device has been switched off. Do not at-
.
8
GB 13