Before Use; Charging The Battery Pack; Attaching/Disconnecting The Battery Pack To/From The Appliance; Checking The Battery Charge Level - Parkside PAAS 12 A1 Originalbetriebsanleitung

Before use

Charging the battery pack

CAUTION!
► Always unplug the appliance before you
remove the battery pack
the battery pack to the high-speed battery
charger .
■ Never charge the battery pack
ambient temperature is below 10°C or above
40°C.
♦ Connect the battery pack
battery charger .
♦ Insert the power plug into the socket. The control
LED lights up red.
♦ The green control LED
charging process is complete and the battery
pack is ready for use.
♦ Push the battery pack
ance.
♦ You should always switch the high-speed charg-
er off for at least 15 minutes between suc-
cessive charging processes. Also disconnect the
power plug from the mains power socket.
Attaching/disconnecting the battery
pack to/from the appliance
Attaching the battery pack:
♦ Click the battery pack
Removing the battery pack:
♦ Press the release buttons
battery pack .

Checking the battery charge level

♦ Press the safety lock-out
OFF switch to check the charge level of the
battery. The status/remaining charge will be
shown on the battery charge level display
as follows:
♦ RED / ORANGE / GREEN = maximum
charge/performance
RED/ORANGE = medium charge/performance
RED = low charge – charge the battery
PAAS 12 A1
from or connect
when the
to the high-speed
indicates that the
back into the appli-
into the handle .
and remove the
and the ON/

Attaching/removing the grip bracket

NOTE
► The grip bracket
removed while the saw blade
Attaching the grip bracket (see fig. A–D):
♦ Press the release button
♦ Push the grip bracket
base plate and onto the appliance.
♦ Lock the release button
Removing the grip bracket:
♦ Press the release
forwards out of the guides.

Fitting/changing the saw blade

Wear protective gloves when fitting/changing a
saw blade .
♦ Turn the quick-release chuck
go in the direction of the arrow and hold it in
this position.
♦ Push the required saw blade
release chuck as far as the stop.
CAUTION!
► The teeth of the saw blade
downwards!
♦ Let go of the quick-release chuck
return to its initial position.
The saw blade is now locked.
cannot be attached/
is attached.
.
over the guides on the
.
and pull the grip bracket
as far as it will
into the quick-
must point
; it must
GB │ MT │
31 ■