Herunterladen Inhalt Inhalt Diese Seite drucken

Grundig RR 740 CD Bedienungsanleitung Seite 11

Inhaltsverzeichnis

Werbung

RR 740 CD / RR 770 CD
- 3 Schrauben O (Fig. 16) herausdrehen und CPU-Platte nach oben
klappen.
- 4 Schrauben P (Fig. 17) herausdrehen und Bedienteil mit Halterung
herausnehmen.
O
Fig. 16
4. Griff ausbauen
- Gehäuseoberteil abnehmen (Pkt. 2).
- CD-Laufwerk ausbauen (Pkt. 6).
- 4 Schrauben Q (Fig. 18) herausdrehen, die beiden Abdeckungen
und die darunter liegenden Plättchen herausnehmen.
- Griff nach oben klappen und durch Eindrücken der Führungs-
Bolzen R auf beiden Seiten des Griffes ausrasten (Fig. 19).
Q
Fig. 18
5. CD-Servo-Platine ausbauen
- Gehäuserückwand abnehmen (siehe Pkt. 1).
- 3 Schrauben S herausdrehen (Fig. 20).
- Hinweis: Vor Abziehen der Flexprintleitung die Sicherungslötstelle
U (Fig. 21) des Lasers kurzschließen (Siehe Seite 1-3
Allgemeiner Teil / Servicehinweise / CD-Teil).
- Platine herausnehmen, gegebenfalls Steckverbinder lösen.
GRUNDIG Service
- Undo the 3 screws O (Fig. 16) then tilt up the CPU PCB.
- Undo the 4 screws P (Fig. 17) then remove the control unit together
with its holder.
4. Removing the Handle
- Remove the top of the cabinet (para 2).
- Remove the CD drive unit (para 6).
- Undo the 4 screws Q (Fig. 18) then remove the two covers and the
small plates located below.
- Tilt the handle up then disengage it by pressing on the guide lugs R
located at the sides of the handle (Fig. 19).
Q
R
5. Removing the CD Servo Board
- Remove the rear of the cabinet (para 1).
- Undo the 3 screws S (Fig. 20).
- Note: Prior to pulling off the Flexprint lead shortcircuit the protective
soldering joint U (Fig. 21) of the laser (Page 1-3 General
Section / Service Hints / CD Section).
- Remove the PCB. If necessary, undo the connector.
S
Fig. 20
Allgemeiner Teil / General Section
P
Fig. 17
Fig. 19
1 - 11

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Gdl 5551Gdl 5451Rr 770 cd

Inhaltsverzeichnis