Further Safety Instructions - Parkside PSS 65 B1 Originalbetriebsanleitung

GB MT
may result in serious personal injury.
• Check damaged parts. This will
ensure that the safety of the power tool
is maintained.
- Before further use of tool, it should be
carefully checked to determine that it
will operate properly and perform its
intended function.
- Check for alignment of moving parts,
binding of moving parts, breakage of
parts, mounting and any other condi-
tions that may affect its operation.
- A guard or other part that is dam-
aged should be properly repaired or
replaced by an authorized service
centre unless otherwise indicated in
this instruction manual.
- Do not use the tool if the switch does
not turn it on and off.
Have defective switches replaced by
an authorized service centre.
There is a risk of injury.
• Warning. The use of any accessory
or attachment other than one recom-
mended in this instruction manual may
present a risk of personal injury.
• Have your tool repaired by a
qualifi ed person. This electric tool
complies with the relevant safety rules.
Repairs should only be carried out by
qualifi ed persons using original spare
parts, otherwise this may result in con-
siderable danger to the user..

Further Safety Instructions

• Connect the device only to a power
point with a RCD (Residual Current De-
vice) with a measured residual current
of not more than 30 mA.
• Keep the mains cable and extension
cable away from the grinding disk and
saw chain. In the event that it is dam-
aged or severed, immediately discon-
54
nect the plug from the socket.
Do not touch the cable before it has
been disconnected from the mains.
Risk of electric shock.
• The replacement of the plug or the
cable must be carried out by the manu-
facturer or his/her customer service in
order to avoid any hazards.
• Only switch the device on once it is
safely fi xed to the worktop.
• For your own safety only use acces-
sories and attachments which were
stated in the operating instructions or
recommended or specifi ed by the tool
manufacturer.
• Only use grinding wheels where the
printed rotational speed is at least as
high as what has been specifi ed on the
name plate of the device.
• Carry out a visual inspection of the
grinding wheel before use. Do not use
any damaged or deformed grinding
wheels. Replace any damaged or worn
grinding wheels.
• Make sure that the sparks produced by
grinding do not present a danger, e.g.
reach people or ignite fl ammable sub-
stances.
• Never keep the fi ngers between the
grinding wheel and spark protection
or in close proximity to the protective
hoods. There is a risk of crushing.
• The rotating parts of the device cannot
be covered due to functional reasons.
Therefore, proceed cautiously and hold
the workpiece fi rmly in order to avoid
slipping which could cause your hands
to come into contact with the grinding
belt or grinding wheel.
• The workpiece gets hot during grinding.
Do not touch the machined area, allow
it to cool down. There is a risk of burn-
ing. Do not use coolants or the like.
• If you are tired or have consumed al-