Setting The Working Pressure; Filter Unit; Draining Condensate Using The Drain Valve - Parkside PDWE 8 B2 Originalbetriebsanleitung

♦ Before using the compressed air maintenance
unit, check the direction of the compressed air
flow using the "▸" mark on the surface. Incorrect
installation will not generate sufficient pressure.

Setting the working pressure

After connecting the compressed air maintenance
unit to a compressed air source, you can adjust the
desired operating pressure by using the air pres-
sure regulator .
♦ First release the locking device by pulling the
air pressure regulator
♦ Turn anticlockwise to reduce the pressure.
Turn clockwise to increase the pressure.
♦ Read the pressure setting from the compressed
air manometer .
♦ Lock the setting by pushing the air pressure
regulator downward.
NOTE
► Make sure that the maximum possible oper-
ating pressure of the compressed air mainte-
nance unit and the compressed air tool used is
not exceeded.

Filter unit

The filter unit is connected to the air pressure
regulator . The maximum working pressure is
8 bar and the working pressure is adjustable from
0.5 to 8 bar. The filter unit
condensate and stores the condensate in the
condensate collector
The fill level of the condensate can be inspected
through the transparent viewing window (see fig.
C). The stored condensate can be discharged via
the drain valve .
GB │ IE
│
■ 16
upwards (see fig. F).
is used to filter
.
Draining condensate using the
drain valve
Ensure that the compressed air maintenance unit is
mounted horizontally so that the condensate can
also be collected horizontally in the condensate
collector . Do not use the filter unit
condensate collector
NOTE
► Before emptying the condensate collector
make sure the compressed air maintenance
unit has been disconnected from the
compressed air source. Otherwise, the
collected condensate may spray out in an
uncontrolled manner.
► The drain valve
disconnected from the compressed air.
■ In order to drain the stored condensate from the
condensate collector
container.
♦ Press against the drain valve
(see fig. G), it will open and the condensate will
flow into the container.
(fig. G)
if the
is not fitted.
opens as soon as it is
, use an appropriate
from below
PDWE 8 B2
,