Read This First - HAPRO Seecret C700 Anleitung

Read this first

The information contained in this manual regarding assembly and operation should be followed in full. Failure to do so may render the product
warranty or liability on behalf of the supplier null and void. If there is any uncertainty as to whether the instructions contained in this manual
have been followed properly and entirely, you should contact the supplier of the appliances.
1 Contact your authorised Hapro dealer
immediately if the appliance does not function
as outlined in this manual.
2 Do not operate this appliance in humid and
chlorine spaces.
3 Always make sure the fuses can carry the load.
This appliance has to be protected by ground
fault circuit interrupter (GFCI) of 0.03A.
4 Always disconnect the power to the appliance
at the wall breaker (isolator) when servicing or
cleaning the in-side construction of the cabin.
Maintenance for which the procedure is not
described in this manual should only be carried
out by a qualifi ed electrician. Never clean the
electrical components with infl ammable and or
chemical fl uids.
5 Ensure that the canopy does not touch the wall
when opened.
6 Prevent the acrylic sheets from coming into
contact with sharp objects.
7 The appliance may not be operated if:
• the acrylic panel in the canopy and/or bench is
missing
• one or more of the fans in the appliance are not
Note
Repairs may only be carried out by qualifi ed personnel.
functioning properly
• the timing mechanism is not functioning
properly
• the temperature inside the cabin is 30°C or
higher
8 To ensure maximum eff ectiveness, replace the
acrylic sheet after 1200 hours.
9 To ensure maximum eff ectiveness, replace the
Seecret XL 100W-R lamp, after 800 hours,
Seecret 25W- R lamp, after 500 hours and the
VitaD + XL 100W, after 650 hours.
10 Check local regulations to fi nd out the proper
procedure for lamp disposal.
11 DesinFact may be used to clean and disinfect
the acrylic sheet. Never use cleaners that
contain alcohol, as these can damage the acrylic
sheet.
12 Emitter and other technical information of the
appliance is indicated on the specifi cation sticker.
13 If the supply cord is damaged, it must be
replaced by the manufacturer or service agent
or a similarly qualifi ed person in order to avoid a
hazard.
14 To replace lamps and starters, remove by
turning a quarter turn to the left. Placement of
new lamps and starters is done in the reverse to
the above mentioned procedure.
15 When installing the appliance, follow the
recommended minimum distances listed in the
"Dimensions / Placement" chapter.
16 Where applicable, clean the dust fi lters after
every 50 hours of use. Regularly (more frequent
than 50 hours) check the dust fi lters.
17 Children should be supervised to ensure that
they do not play with the appliance.
21 Non-users, especially children, must not be
present when the appliance is being operated.
5