Recommendations And Suggestions - Beko CTB 6250 W Bedienungsanleitung

1

Recommendations and Suggestions

The Instructions for Use apply to
several versions of this appliance
A
Accordingly,
descriptions of individual features
that do not apply to your specific
appliance
1.1 Installation
• The manufacturer will not be held liable for any
damages resulting from incorrect or improper
installation
• The minimum safety distance between the
cooker top and the extractor hood is 650 mm
(some models can be installed at a lower height,
please refer to the paragraphs on working di-
mensions and installation)
• Check that the mains voltage corresponds to
that indicated on the rating plate fixed to the
inside of the hood
• For Class I appliances, check that the domestic
power supply guarantees adequate earthing
• Connect the extractor to the exhaust flue
through a pipe of minimum diameter 120 mm
The route of the flue must be as short as pos-
sible
• Do not connect the extractor hood to exhaust
ducts carrying combustion fumes (boilers, fire-
places, etc )
• If the extractor is used in conjunction with
non-electrical appliances (e g gas burning ap-
pliances), a sufficient degree of aeration must
be guaranteed in the room in order to prevent
the backflow of exhaust gas The kitchen must
have an opening communicating directly with
the open air in order to guarantee the entry of
clean air
1.2 Use
The extractor hood has been designed exclusively
for domestic use to eliminate kitchen smells
• Never use the hood for purposes other than for
which it has been designed
Hood / User Manual
you may find
• Never leave high naked flames under the hood
when it is in operation
• Adjust the flame intensity to direct it onto the
bottom of the pan only, making sure that it does
not engulf the sides
• Deep fat fryers must be continuously monitored
during use: overheated oil can burst into flames
• The hood should not be used by children or per-
sons not instructed in its correct use
1.3 Maintenance
• Switch off or unplug the appliance from the
mains supply before carrying out any mainte-
nance work
• Clean and/or replace the Filters after the speci-
fied time period (Fire hazard)
• Clean the hood using a damp cloth and a neutral
liquid detergent
126
5 / EN