Included Items; Technical Information; General Safety Advice For Electrical Power Tools - Parkside PMGS 12 Bedienungs- Und Sicherheitshinweise

Mains adapter (see Fig. A):
Plug-in device for plug
7
Tray
8
Mains adapter
9
Power cable (with mains plug)
10
Accessories (see Fig. B):
6 HSS drills
11
2 Mandrels for mounting tools
12
3 Polishing wheels
13
4 Grinding wheels
14
1 Metal brush
15
1 Saw blade
16
10 Cutting wheels
17
5 Collets
18
2 Plastic brushes
19
3 Milling bits
20
2 Engraving bits
21
5 Grinding bits
22
Combination tool
23

Included items

Q
1 Small drill
1 Mains adapter
1 Plastic case
1 Accessory kit (45-piece)
1 Operating instructions

Technical information

Q
Small drill PMGS 12:
Nominal voltage:
Nominal output:
Idle-running speed:
Max. drill bit diameter: 3.2 mm
Certified acc. to:
Noise and vibration data:
Values determined in accordance with EN 60745
The sound pressure level (A-weighted) of the device
is typically 61 dB (A). Uncertainty K = 3 dB. The
sound level while working can exceed 75 dB (A).
Introduction / General safety advice for electrical power tools
3
12 V
22 W
n 5,000 - 20,000 min
-1
0
EN60745-1; EN60745-2-1
Evaluated acceleration, typical:
Hand / arm vibration: 2,63 m / s
Uncertainty K = 1,5 m / s
WArNING!
The vibration level given in these
instructions has been measured in accordance with
a standardised measurement procedure specified
in EN 60745 and can be used to compare devices.
Different uses of the device give rise to different
vibration levels and in many cases they may exceed
the values given in these instructions. It is easy to
underestimate the vibration load if the electrical pow-
er tool is used regularly in particular circumstances.
Note: If you wish to make an accurate assessment
of the vibration loads experienced during a particular
period of working, you should also take into account
the intervening periods of time when the device is
switched off or is running but is not actually in use.
This can result in a much lower vibration load over
the whole of the period of working.
Mains adapter PMGS 12-1:
INPuT:
Rated voltage: 230 V ~ 50 Hz
OuTPuT:
Nominal voltage: 12 V
Nominal current: 1 A
Protection class: II /
Certified acc. to: EN61558
General safety advice
for electrical power tools
read all the safety advice
WArNING!
and instructions! Failure to observe the safety
advice and instructions may result in electric shock,
fire and / or serious injury.
KEEP ALL THE SAFETY ADVICE AND INSTRUC-
TIONS IN A SAFE PLACE FOR FUTURE REFER-
ENCE! THE TERM "ELECTRICAL TOOL" USED
IN THE SAFETY ADVICE REFERS TO ELECTRICAL
TOOLS POWERED BY MAINS ELECTRICITY (BY
2
2
GB/IE/CY 7