Herunterladen Inhalt Inhalt Diese Seite drucken

Programming Bus-2 Address; Led Indicators; Installation Guidelines - Honeywell IDENT-KEY 3 Montage, Anschluss, Anleitung

Bus-2
Vorschau ausblenden Andere Handbücher für IDENT-KEY 3:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

46
5.

Programming BUS-2 address

The DIP switches located in the IDENT-KEY evaluation
unit (address switch S1) are for setting the BUS-2 user
address. The individual codes can be found in the
programming protocol of the intrusion detection control
panel.
6.

LED indicators

JP22
Address
switch
BUS-2
LD1 LD2
Yellow
Green
7.

Installation guidelines

The BUS connection lead
the diagram below.
The corresponding line cross-sections can be found in the
detection control panel (Chapter on lines). The shield terminal should also be kept as short as
possible to avoid the risk of an unintentional short circuit.
control panel
Data
0 V
+12 V DC
U_b
0 V
+12 V DC
U_ext.
0 V
Shield
Mounting and Connection Instructions IK3 Evaluation Unit BUS-2
Indicated switch position =
Normal operation:
- RAM is initialized when started
- When in operation, EU is
initialized by the central control
unit.
Boot loader active
- Firmware downloaded
- Testing firmware after update
- Faulty firmware
must
be a shielded cable stranded in pairs and the cores laid according to
Address switch S1
Address 5
set!
Installation Manual
BUS-2
32
16
8
Address value
4
2
1
LD1
Off
LD2
Flashes 1x
LD1
Off
LD2
Flashes 50ms / 2s
LD1
Always off
LD2
LD1
LD2
LD1
LD2
of the intrusion
EU ST1/ST2
Shield
Data
0 V
+12 V DC
0 V
+12 V DC
0 V

Quicklinks ausblenden:

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis