Adjustments; Adjusting The Head Strap, Fig . A; Adjusting The Ear Protectors, Fig . B - D; Adjusting The Visor, Fig . E - Parkside PFSH 3 A2 Originalbetriebsanleitung

■ The pads of the ear protectors will show signs
of wear over time . Examine them for tears or
loose spots after each use .
■ Do not clean the ear protectors with chemicals
or substances that are harmful to the wearer .
■ Certain chemical substances can damage this
product . Detailed information is available from
the manufacturer .
■ Ear muffs and especially their foam padding
can wear down over time . Examine them
regularly for tears, loose spots and other signs
of wear .
■ Covering the foam pads with hygiene covers
can compromise the acoustics of the ear muffs .
WARNING!
► Failure to comply with the safety instructions
provided for the ear protectors can seriously
compromise their protective effect .
■ Always flip down the visor when wearing the
helmet .
■ It protects you from flying objects .
■ The visor does not offer protection from splash-
ing liquids (including liquid metals), hot objects,
electricity and infrared/UV rays .
■ Do not use the visor in environments with a pre-
dictable risk from hard or sharp flying objects .
■ Wood shavings and their resin can damage the
visor and impair its transparency .
WARNING!
► The visor is tested for increased mechanical
strength and corresponds to mechanical
strength class "S" .
■ 22 │ GB │ MT

Adjustments

Adjusting the head strap, fig . A

♦ Turn the head strap adjuster
head strap to fit your head .
♦ The headband should fit your head snugly
when you put on the helmet .
♦ Tighten the headband by turning the head strap
adjuster clockwise .
♦ Loosen the headband by turning the head strap
adjuster anticlockwise .
■ The helmet must sit firmly on your head without
exerting uncomfortable pressure .
CAUTION!
►
Always make sure that the helmet is adjusted
correctly when using it .

Adjusting the ear protectors, fig . B - D:

You can adjust the height and position of the ear
protectors .
♦ Push down the bracket of the ear protectors
to lock the ear protectors
♦ Slide the ear protectors
them to the required height (see fig . B) .
♦ Turn the ear protectors
required position (see fig . C) .
♦ Flipping the ear protectors
it easier to put them on or take them off .
If this causes the tension to decrease, retighten
the ear protectors while they are folded in by
using the ear protector adjuster
♦ Slide the ear protector adjuster
"+" to increase the tension (see fig . D) .
♦ Slide the ear protector adjuster
"–" to decrease the tension (see fig . D) .

Adjusting the visor, fig . E

You can adjust the distance between the visor
and your face by moving the visor manually (see
fig . E) .
Alternatively, you can flip the visor
to adjust the
onto your ears .
up or down to set
to set them to the
outwards makes
.
towards the
towards the
all the way up .
PFSH 3 A2