General Safety Instructions - Parkside PFSH 3 A2 Originalbetriebsanleitung

H-value M-value
(high (medium
level) level)
29 dB 21 dB
Explanation of the symbols used on the helmet:
Figure F:
1 .) CE marking
2 .) Applied standard
3 .) Helmet size
Figure G:
4 .) Material
Figure H:
5 .) Month of manufacture
6 .) Year of manufacture (e .g . 2019)
Explanation of symbols on the visor:
Figure I:
7 .) Manufacturer type
8 .) Applied standard
9 .) Symbol for increased strength
Applied standards:
The helmet has been examined as per:
EN 397: 2012+A1: 2012
The ear protectors have been audited as per:
EN 352-3: 2002
The visor has been audited as per:
EN 1731: 2006
Identification number, name and address of
the inspection body:
2754 ALIENOR CERTIFICATION
ZA du Sanital – 21 Rue Albert Einstein
86100 CHATELLERAULT-France
PFSH 3 A2
L-value SNR
(low level) value
(single
number
rating)
12 dB 23 dB
General safety
instructions
WARNING!
► Read all safety warnings and all instructions .
Save all warnings and instructions for future
reference.
Please pay close attention to the following informa-
tion and safety instructions to ensure the best possible
protection and comfort .
■ Whenever you use the helmet, first check that
all components are properly attached, adjusted
and serviced .
■ Always use the helmet with the correct settings
to ensure the required protection .
■ The helmet cannot guarantee complete protec-
tion against injury . It does not replace adher-
ence to safe work procedures .
■ Never modify the structure or varnish of the
helmet .
■ The helmet must not come into contact with
liquids containing solvents or alcohol . These
substances can damage the plastic .
■ Knocks or other impacts can cause impercep-
tible impact damage to the helmet, such as
hairline cracks . This compromises the protection
afforded by the helmet, especially in emergen-
cies . Replace the helmet if it has been subject to
extreme stresses .
■ Examine the helmet for damage (cracks, tears)
before every use . Only use the helmet and ac-
cessories if they are in a flawless condition .
■ Do not modify the helmet as this could compro-
mise its protective effect .
■ Please adhere to all instructions and tips
re garding assembly, adjustments and mainte-
nance of the ear protectors .
■ The ear protectors are intended to protect your
ears in noisy areas .
■ They should be worn for as long as the noise
persists .
GB │ MT │ 21 ■