Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
12
1. Description of the ap-
pliance
The appliance described in this manual is a heated
suction table to be used in combination with an
iron. The appliance is intended for household or
semi-professional use only. The appliance can
be used only by adults. The appliance must be
used only to iron garments and linen. Any other
usage is to be considered improper and, therefore,
potentially harmful.
2. First usage
Unpack the appliance and make sure that the
follwoing items are included in the box:
A. Support for boiler
B. Surface padding
C. Garment tray
Dispose of cardboard and plastic according to the
recycling policy valid in your area.
Assemble the accessories as shown in Figure 2:
A. Mount the support for the boiler
B. Cover the table with the padding provided
C. Slip the garment tray onto the frame
3. Usage
3.1. Setup
Refer to Figure 3.
•
Put the folded machine flat on the floor.
•
Release the cord that holds the table folded
(D)
•
Raise the surface and insert the bar into the
notch most suitable to the desired height (E)
•
Insert the plug in a suitable socket (230V
50Hz)
•
Place the boiler on the support and insert its
plug into the built-in socket of the table (F).
•
Turn on the switch of the table (2 - Figure 1).
The heating element of the table begins to
heat: after a while you will feel that the ironing
surface becomes warm.
3.2. Ironing
Keep the pedal depressed to activate suction.
Suction allows to block the garments on the ironing
surface and removes steam from the fabric.
For professional-quality pressing, we suggest to
operate as follows:
•
Lay the garment on the ironing surface
•
Activate suction and, with your hands, flatten
the fabric on the surface
•
Keeping suction active, iron the fabric using
steam
•
Leave suction on for some seconds in order
to remove all humidity. When the fabric is dry
and cool it does not get wrinkled when it is
removed from the table.
When ironing with steam, use suction in order to
avoid condensate to build up inside the table.
-
The iron must be used and rested on a stable
surface;
-
when placing the iron on its stand, ensure that
the surface on which the stand is placed is
stable;
-
the iron is not to be used if it has been dropped,
if there are visible signs of damage or if it is
leaking.
WARNING - Do not leave a hot iron on
the cover: the cover may change color.
WARNING – The legs of the table termi-
nate with antiskid caps. When the table is
open, do not attempt to move it by pushing it:
it may fall injuring you or somebody else.
WARNING - Do not leave the table
covered in garments when it is on: the
heat from the table may damage the fabric or
cause a fire.
3.3. End of the job
Refer to Figure 4
•
Turn off the switch (2 - Figure 1)
•
Disconnect from the mains
•
If a boiler is connected to the table, disconnect
the plug of the boiler and remove the boiler
from the support
•
Fold the support on the ironing surface (G -
Figure 4)
•
The power cord and the cable can be stored in
the compartment of the table
•
Using both hands raise the surface to unhook
the height-notch. Then lower the table to the
floor. (H - Figure 4)
•
Tie the legs and surface together with the cord
F4TD
F4TD/2-ed3706
Werbung
Inhaltsverzeichnis
