Soldering; Maintenance And Cleaning - Parkside PLS 30 Bedienungs- Und Sicherheitshinweise

Soldering

Q
— The soldering pencil has a rated output of 30 watts and is there-
fore ideal for electronics soldering.
— The design of the soldering pencil makes it especially suitable for
use where access is difficult or for fine soldering work.
— To achieve the best results use electronics solder 1.0 (10 g elec-
tronics solder with integrated flux is included) or 1.5 mm diameter
60 % Sn. We recommend the use of soldering paste (not soldering
grease or soldering fluid) as a flux.
j
Clean the soldering tip
j
After cleaning the tip
This is done by melting solder on to the hot soldering tip
j
Guide the soldering tip
j
Place the solder (with flux) between the joint site and the tip
to melt it.
j
Continue to feed further solder until the whole joint has a covering
of solder.
j
Then quickly remove the soldering tip in order to avoid overheating
the molten solder.
j
Allow the solder to harden while not subjecting it to vibration or
movement.
j
Note: The flux is either already contained in the solder or applied
separately. Ask the advice of the retailer when buying solder in or-
der to choose the most suitable solder for your intended purpose.

Maintenance and cleaning

Q
WArNING!
on the device always pull the mains plug out of the mains socket and
allow the device to cool.
Operation / Maintenance and cleaning
on the moist solder sponge
2
it must be "tinned" (coated with solder).
2
to the intended joint site and heat the joint.
2
rISK OF INJUrY! Before you carry out any work
.
8
.
2
2
GB/MT 63